AOTC DC-15 Tutorial
Under Construction
Tutorial by : TK1215
MG-34 templates have not been converted, but easy to do.
Download the templates Here.


The barrel: 1 3/4 inch PVC cut to 29.5 inches in length. It could be a bit smaller, it's about
two inches longer that my MG-34 if that matters.
The scope: The front is 1 3/4 inch PVC (2 inches in length) connected to 1 1/2 inch PVC
with one end sanded down to mach the 1 3/4 inch piece(4 inches in length), with a spacer
in between, 1 1/2 inch PVC (3/4 inches in length) . I added a piece of wood below the spacer and
attached it to the scope rail.

The partial grip on the E-11 portion of the rifle. Length = 8 3/4 inches, Height = 3 1/2 inches.

There's a few things I would change if I were to do another, one is the folding stock
(or whatever it is) the flat part on the front isn't accurate on mine, it shouldn't be that wide
and should be thicker (as seen in the reference shot above). The other would be the
scope rail, it needs to be a bit longer in the back. Oh and I didn't add the clip housing
on mine so it could be hung on the wall the way I wanted. Otherwise it's pretty close.