ANH DH-17 Tutorial
Under Construction
Tutorial by : TK1215
First you will need to download the Templates needed for this project Here.

<hr>
The Barrel Tip: I used a small air mattress pump accessory for
the one pictured. I anyone finds something a bit more common
for this part, email me! Here Thanks!
Cut a 15.5" long piece of 1-1/4 PVC pipe. Mark all the way around
the pipe at 4.5 from the barrel end of the PVC pipe. Cut a
separate piece of 1-1/4 pipe at 4.5. With a ruler mark however
many segments you want on your blaster (there are 12 in
the movie version). Quick set PVC glue the segments
on the barrel at the same distance apart.
Using the E-11 templates, make your ejector cutout.




The sight rail is Aluminum with a little plastic bottle cut in half, with groves cut in one end (to represent the springs). I made the front sight out of sheet Styrene, cut a hole in the end for the rail. The Clip housing holder was made from sheet Styrene built up to the proper height and shape, then glue it on with PVC glue. Make the handle out of the E-11 templates.




Make the butt cap just like the E-11. The scope mounts are Daisy from Wal-mart. Rivet a piece of 1" wide Aluminum to the scope rail, so the scope mounts have something to grab onto. Putty, sand, prime. Sand, Prime.




The finished product! Doesn't it feel good!




Custom Display Stand link.